Using existing PIR Motion Intruder Alarm with my wireless camera? - wireless intruder alarms
Hello,
I have installed 2 wireless camera in my parking lot at the time, I noticed that after 3-4 hours of work of these cameras are beginning to show signs (can be caused by heat, etc..)
Now I work) an alarm PIR (with batteries, in any way you can connect the movement of the PIR intruder alarm in the power of the camera, in conjunction, so that sounds only when the camera detects motion and detection of pictures on the computer The camera controls stored.
PIR Alarm is a unit with a built-in alarm
Regards,
SA
Saturday, January 9, 2010
Wireless Intruder Alarms Using Existing PIR Motion Intruder Alarm With My Wireless Camera?
1 comment:
It seems that the real problem has more to do with cameras. To stop working why? When it is hot, sure, that you protected from the sun. It is also possible that the supplies are not adequate. Perhaps the tension is somewhat higher than it should be, then heats up the camera or something. I found this type of cameras often require a regulated power supply. You have to find someone to take care of them. Therefore, the alarm unit.
In theory, the burglar-alarm systems in a position to control cameras, even if they only used to control the power for themselves.
You must ensure that the supply voltages, which are adapted PIR unit and the wiring of alarm contacts. If no contact (relay) may not be suitable.
Post a Comment